Many inexperienced plastic mold factory masters have finished the mold after a series of procedures, and then put it aside, waiting for the customer acceptance. Who knows when the customer comes to the acceptance, put on the injection molding machine, found that the product produced has been very different from the sample. What is the situation? This is because many beginners do not know how to store molds.

Now let's look at how to store plastic moulds.

1. mold storehouse for storing molds should be well ventilated, damp proof and easy to store, put in and take out.

2. when storing molds, they should be stored in groups according to their parts and placed neatly.

3. Small molds should be kept on the shelf, large and medium molds on the bottom and the entrance, the bottom should be flat with pillow mats.

4. When the mould is in storage, it should be scrubbed and tested clean. Lubricating oil should be injected into the oil storage hole at the top of the guide post and paper should be covered to prevent dust and sundries from falling into the guide sleeve and affecting the guiding accuracy.

5. Antirust oil should be coated on the edge of punch and die, cavity and guide cylinder surface to prevent long-term storage of rust.

6. In order to avoid the long-term failure of the unloading device, a limited block should be padded between the upper and lower dies of the die when storing the die.

7. mold upper and lower die should not be disassembled and stored, so as not to damage working parts.

8. Moulds shall be periodically identified for technical status, and unqualified moulds shall be repaired or scrapped in time, and shall be treated in isolation.

If the plastic mold factory can be in place according to the above plastic mold storage method, we believe that the plastic mold will be able to store well.